Sharp Actius PC-GP20 Betriebsanweisung PDF herunterladen (Seite 19)

Intel

StrongARM

SA-1110 Development Board

User’s Guide

2-7

Getting Started

3. Insert the power jack that is connected to the wall brick into J10 (see Figure 2-4 for the

location of J10).

Note: The power jack may have to be rotated to its flat side to accommodate any other connectors in J10.

4. Plug in the wall-brick into an AC outlet.

5. See the Readme.txt file for success and failure indications of start-up diagnostic results and

how to proceed.

To disconnect power, remove the power jack from J10 and wait for the super cap to discharge

(typically less than 5 minutes).

Note: If sleep mode was entered as a result of VDD_FAULT or BATT_FAULT signals, GPIO 0 and

GPIO 1 are the only wake up events that can bring the SA-1110 out of sleep mode.

2.2.2 Connecting Power from the Li-Ion Battery

Use the following procedure to provide power to the SA-1110 Development Board from the Li-Ion

battery:

Figure 2-4. AC Power Input Jack Location

A7615-01

J10

J11

J17

J16

J14

Headset Jack

2.5 mm

USB Type B

Connection

Stereo Jack

3.5 mm

Base Station

Power Input Jack

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 89 90

Keine Kommentare

Sharp Actius PC-GP20 Betriebsanweisung Seite 19