Sharp PC-9800T Spezifikationen PDF herunterladen (Seite 15)

<Ver. 2.1>

Installation conditions

3.2.4 Strain on surface where equipment is installed

1 This display uses glass in its display section. When using a third-party metal fixture, check that strain is 1 mm or

less by the following method.

2 Tightly fit a thread using a force of

0.1psi or less diagonally through the mounting bolt openings on the mounting

surface, as shown in the drawing.

3 Measure distance L of the intersection of the strings in the center section.

The relationship between strain and L is given by Strain = L × 2.

4 If L is 0, interchange the front and rear positions of two strings and check the distance again. If the value of L is not

0, it is the true value of L. If L is 0 after the position is changed, strain is approximately 0.

Holes for

mounting

bolts

Plasma display-mounting surface

(mounting metal fixture)

Enlarged drawing of the intersectional part A

(showing the part obliquely)

Thread

Right angle

Point e is the center of the thread a-b.

Point f is the center of the thread c-d.

Distance between e and f = L

Points e and f are indicated in an en-

larged figure for more detailed under-

standing.

Thread

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 135 136

Keine Kommentare

Sharp PC-9800T Spezifikationen Seite 15