Sharp R-310J Betreibershandbuch PDF herunterladen (Seite 15)

Page 15

4. Place a product on the rollers and move the product and roller assembly so

the product contacts the drive roll evenly.

5. Position the whole carriage at an angle (Fig 9b). This is so the label starts

onto the product at an angle. This may seem contradictory, but the label must

start at an angle so it ends up looking straight on the product.

The Drive roller may need to be moved to allow the product contact the roller

parallel by loosening the 4 set screws (L, Fig 9c). Also the bottle stop was

positioned so the product rests against it for consistent label placement.

Snug all screws and label a product or two and examine it for wrinkles or

position. Tighten all screws when adjustments are finished.

Fig 9b

Note: Tapered

Product must

contact Drive

roll parallel for

straight label

transfer.

Fig 9c

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 45 46

Keine Kommentare

Sharp R-310J Betreibershandbuch Seite 15