Sharp R-8730-A Spezifikationen PDF herunterladen (Seite 6)

INSTALLATION

READ THIS CAREFULLY BEFORE STARTING THE INSTALLATION

Unpack the unit. Inspect all components for completeness and

condition. Ensure that all packing materials have been removed

from the unit.

LEVELING THE UNIT

Verify that an adjustable leg is installed at each corner of the

grinder.

Set grinder in its operating location. Level the grinder. A spirit

level should be placed on the top of the unit, at the edge, as a

guide when making level adjustments.

Level the unit from left to right and front to back by turning the

adjustable feet. Be sure all four feet touch the counter to prevent

tipping.

ELECTRICIAN’S INSTALLATION INSTRUCTIONS

IMPORTANT:

Supply power must match nameplate for voltage and phase.

Connecting to the wrong voltage will damage the brewer or result

in decreased performance. Such damage is not covered by

warranty.

IMPORTANT:

The ground prong of the plug is part of a system designed to

protect you from electrical shock in the event of internal damage.

Never cut off the ground prong nor twist a blade to fit an existing

receptacle. Contact a licensed electrician to install the proper

circuit and receptacle.

REFER TO ELECTRICAL SPECIFICATIONS - Page 1

Check the nameplate to determine correct electrical service

required for the grinder to be installed.

Models 8730 are equipped with a cord and plug.

120V units require a 115 - 125 volt 20 amp circuit (50/60 Hz,

2 wire plus ground, with NEMA 5-15R or 5-20R Receptacle).

220V and 240V units require an appropriate circuit (50/60 Hz,

2-wire plus ground).

CAUTION:

ELECTRICAL

DAMAGE

DO NOT plug in or energize this

appliance until all Installation

Instructions are read and

followed. Damage to the

grinder may occur if these

instructions are not followed.

CAUTION:

UNSTABLE

EQUIPMENT HAZARD

It is very important for safety

and for proper operation that the

grinder is level and stable when

standing in its final operating

position. Provided adjustable,

non-skid feet must be installed

at each corner of the unit.

Failure to do so will result in

movement of the brewer which

can cause personal Injury and/

or damage to grinder.

WARNING:

SHOCK HAZARD

Grinder must be properly

grounded to prevent possible

shock hazard. Electrical shock

will cause death or serious

injury.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare

Sharp R-8730-A Spezifikationen Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mikrowellen Sharp R-8730-A