Sharp UX-A260U Wartungshandbuch PDF herunterladen (Seite 5)

1 – 3

UX-A260U

Plug the power cord

into a 120 V grounded

outlet.

Connect the telephone

line cord to the TEL.

LINE jack and a wall

telephone jack.

Attach the paper tray

and document support.

Load the imaging film.

1. Open the operation panel (press ).

3. Insert the green gears.

IMPORTANT: Do NOT discard the

green gears. They are not included

with replacement imaging film.

Note: To enter your name and fax number and set the date and time so that they

appear at the top of each fax you send, see pages 17 - 20 of your operation manual.

2. Remove the imaging film from its packaging.

Cut the band that holds the rolls together.

Connect the handset

and place it on the

handset rest.

4. Insert the film into the print compartment.

5. Rotate the front spool as shown

until the film is taut.

6. Close the operation panel (press

down on both sides to make sure it

clicks into place).

Load paper.

Note: If you loaded legal paper, see page 16 of the

operation manual to change the paper size setting

to LEGAL.

Select the reception mode for incoming faxes

and voice calls:

FAX mode: The machine automatically

answers all calls and begins fax reception.

TEL mode: Lift the handset when the machine

rings. Press to begin fax reception.

TAD mode: Select this mode when you go out

to receive both voice messages and faxes.

(Note: To select TAD mode, you must first

record an outgoing message.)

START/MEMORY

Click!

Fit ends of

rolls onto hubs

The arrow in the

display points to

the selected

reception mode.

RESOLUTION/

RECEPTION MODE

1 slot

2 slots

Make sure

the gears fit

into the slots

in the ends of

the rolls.

Insert the paper

print side down.

The stack

should not

be higher

than this line

•

GENTLY LOAD PAPER INTO THE PAPER TRAY.

•

DO NOT FORCE IT DOWN INTO THE FEED SLOT.

FAX

TEL

JAN-01 10:30

FAX

TEL

JAN-01 10:30

FAX

TEL

JAN-01 10:30

TAD

Record an outgoing

message (greeting) for TAD

mode inviting callers to leave

a message.

(Note: ìTA Dî stands for

ìTelephone Answering

Deviceî.)

1. Press , , and .

2. Lift the handset, press

, and speak into the

handset.

3. When finished, press .

REC/

MEMO

START/MEMORY

STOP

Note: If the

support does

not go in,

turn it over.

[5] Quick setup guide

[3] Transmittable documents

Refer to the service manual of UX-P100U.

[4] Installation

Refer to the service manual of UX-P100U.

1 2 3 4 5 6 7 8 9 10 ... 75 76

Kommentare zu diesen Handbüchern

Keine Kommentare

Sharp UX-A260U Wartungshandbuch Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Multifunktionsgeräte Sharp UX-A260U