Sharp JX-9500H Betriebsanleitung PDF herunterladen (Seite 24)

Xprint F.A.Q. Document revision 10 (16.09.2008)

Page 24/89

H. Printer connection

H.1 How to define a printer connected to an Axis box ?

Printing to a printer connected to an Axis box is possible by using the axis fast filter. This filter allows not only to

submit print jobs but also to have a follow-up of the printer status (as for example Printer Off, Paper End , ....).

Prerequisites :

- Axis box connected to the network via TCP/IP

- UNIX System V Release 4

Axis configuration :

To establish communication with the TCP network, the Internet address and the host name must be included

in your system host table and downloaded in the Axis box.

- create communication end point in the local /etc/hosts file

Example:

< internet address > < host name >

112.418.198.200 axis

- send the address to the Axis box using arp command

arp -s <host name> <ethernet address >

where ethernet address is the serial number of your Axis box .

Example:

arp -s axis 00:32:8c:18:00:12

ping axis (check that axis is alive )

Xprint configuration :

- add the axis fast filter into the Xprint configuration

Example:

xpadd -flt axis -tp FAST -cm prosbsd -op "PRINTER *=*" "COMMENT *=*"

- create a Xprint device connected to the Axis box

Example :

xpadd -dev <device name> -da "axis 35" -fl axis -ca "PR1" -co LAN -pc < PCL name>

where the device address (-da) is set as follow

axis host name

35 port number fixed to 35

and the administrator comment (-ca ) is set to the physical printer ports.

The factory default configuration is :

PR1 LPT1 (parallel)

PR2 LPT2 (parallel)

PR3 COM1 (serial)

PR4

COM2 (serial)

One to four printers can be connected to the Axis box depending on the box model.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 88 89

Keine Kommentare

Sharp JX-9500H Betriebsanleitung Seite 24