Sharp XV-Z30000 Operation Bedienungsanleitung

MODELXV-Z30000PROJECTORSETUP MANUALConnecting Pin Assignments ... 2RS-232C Specifi cations and

-102. Setting an IP Address for the ComputerThe following describes how to make settings in Windows Vista®.1 Log on the network using the administrat

-11Setting up the Projector Network Environment5 Click “Internet Protocol Version 4 (TCP/IPv4)”, and click the “Properties” button.6 Confi rm or chang

-123. Setting the Projector Using Internet Explorer Complete connections to external equipment before starting the operation. (See pages 23-27 of the

-13Resetting the Lamp Timer of the Projector via LANWhen the projector is connected to a network, you can use the communications program to send a com

-145 Click “Properties” on the “File” menu.6 Click the “Settings” tab, and then click “ASCII Setup”.7 Select the check boxes next to “Send line end

-15TroubleshootingCommunication cannot be established with the projectorWhen connecting the projector using serial-connection? Check that the RS-232C

-16? Take the following steps for checking the network settings for the computer.1. Open a command prompt. Click “start” ➔ “All Programs” ➔ “Accessor

-17? Check if the “TCP/IP” protocol is operating correctly using the “PING” command. Also, check if an IP address is set.1. Open a command prompt. Cl

-2Connecting Pin AssignmentsCOMPUTER/COMPONENT input Terminal: mini D-sub 15 pin female connectorCOMPUTER Input COMPONENT InputPin No. Signal Pin No.

-3RS-232C Cable recommended connection: D-sub 9 pin female connectorPin No. Signal Pin No. Signal1.2.3.4.5.6.7.8.9.CDRDSDERSGDRRSCSCI1.2.3.4.5.6.7.8.9

-4RS-232C Specifi cations and CommandsComputer controlA computer can be used to control the projector by connecting an RS-232C serial control cable (cr

-5CommandsExample: When turning on the projector, make the following setting.Computer ProjectorPOWR___1omOKControl Contents Command ParameterReturnPow

-6Control Contents Command ParameterReturnPower ONStandby mode(or 30-second startup time)COMPUTER INPUT Picture Mode Standard R A P S _ _ _ 1 OK or ER

-7Control Contents Command ParameterReturnPower ONStandby mode(or 30-second startup time)HDMI2 Picture Mode Standard R D P S _ _ _ 1 OK or ERR ERRMovi

-8Setting up the Projector Network EnvironmentThis section describes the basic procedure for using the projector via the network.If the network is alr

-91. Connecting the Projector to a ComputerEstablishing a one-to-one connection from the projector to a computer. Using a commercially available LAN c