Sharp XV-Z100 Spezifikationen PDF herunterladen (Seite 56)

• If two or more input signals are found, the pro-

jector selects the input source in the order of

INPUT 1 INPUT 2 INPUT 3 INPUT 4

when you press INPUT (P /R ) on the projector.

• While “Auto Search” is set to “On”, press

C INPUT 1,C INPUT 2, D INPUT 3 or

E INPUT 4 on the remote control to select

an input mode other than the input mode se-

lected by the projector.

• Auto Sync adjustment is also performed by

pressing F AUTO SYNC on the remote con-

trol.

• The Auto Sync adjustment may take some time

to complete, depending on the image of the

computer connected to the projector.

• When the optimum image cannot be achieved

with Auto Sync adjustment, use manual ad-

justments. (See page .)

Off

Auto Sync adjustment will

occur when the projector is

turned on or when the input

signals are switched, when

connected to a computer.

Auto Sync adjustment is not

automatically performed.

• When the Auto Power Off function is set to

“On”, 5 minutes before the projector enters

standby mode, the message “Enter STANDBY

mode in X min.” will appear on the screen to

indicate the remaining minutes.

Off

When no input signal is detected for

more than 15 minutes, the projector will

automatically enter standby mode.

The Auto Power Off function will be

disabled.

Downloaded From projector-manual.com Sharp Manuals

Regarding the Lamp (Continued)

Remove the lamp unit.

• Loosen the securing screws from the

lamp unit. Hold the lamp unit by the

handle and pull it in the direction of the

arrow. At this time, keep the lamp unit

horizontal and do not tilt it.

Resetting the Lamp Timer

Reset the lamp timer after replacing the lamp.

Insert the new lamp unit.

• Press the lamp unit firmly into the lamp

unit compartment. Fasten the securing

screws.

Replace the lamp unit cover.

• Align the tab on the lamp unit cover

(1)and place it while pressing the tab

(2) to close it. Then tighten the user ser-

vice screw to secure the lamp unit cover.

Connect the power cord.

• Plug the power cord into the AC socket

of the projector.

Reset the lamp timer.

• While simultaneously holding down

UMENU/HELP, TENTER and R on the

projector, press SSTANDBY/ON on the

projector.

• “LAMP 0000H” is displayed, indicating

that the lamp timer is reset.

• Make sure to reset the lamp timer only when

replacing the lamp. If you reset the lamp timer

and continue to use the same lamp, this may

cause the lamp to become damaged or ex-

plode.

Info

AC socket

Securing screws

Handle

ENTER button

MENU/HELP

button

R button

• If the lamp unit and lamp unit cover are

not correctly installed, the power will not

turn on, even if the power cord is con-

nected to the projector.

Info

STANDBY/ON

button

XV-Z100_EN_l 05.8.25, 5:58 AM52

Downloaded From projector-manual.com Sharp Manuals

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 64 65

Kommentare zu diesen Handbüchern

Keine Kommentare

Sharp XV-Z100 Spezifikationen Seite 56

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Datenprojektoren Sharp XV-Z100