Sharp R-222 Spezifikationen PDF herunterladen (Seite 15)

E - 3

INSTALLATION INSTRUCTIONS

1. Remove all packing materials from the oven cavity and the feature sticker from the oven door panel

(if available). Check the unit for any damage, such as a misaligned door, damaged door seals around the

door or dents inside the oven cavity or on the door. If there is any damage, please do not operate the

oven until it has been checked by the SHARP SERVICE CENTER and repaired, if necessary.

2. Accessories provided

1) Turntable 2) Roller Stay 3) Operation Manual

3. Fit the roller stay and turntable referring to OVEN DIAGRAM below. Place the roller stay on the bottom of

oven and seat the turntable on the roller stay, while aligning well with the coupling in the centre.

NEVER use the oven without the turntable and roller stay.

4. The oven should not be installed in any area where heat and steam are generated, for example, next to

a conventional oven unit.

The oven should be installed so as not to block ventilation openings.

Allow space of at least 15 cm from top of the oven for air ventilation.

This oven is not designed to be built-in to a wall or cabinet.

5. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or

personal injury for failure to observe the correct electrical connecting procedure.

The A.C. voltage and frequency must correspond to the one indicated on the rating plate on the back of

the oven.

6. This appliance must be earthed:

IMPORTANT

The wires in power supply cord are coloured in accordance with the following code:

Green-and-yellow : Earth

Blue : Neutral

Brown : Live

As the colours of the wires in the power supply cord of this appliance may not correspond with the

coloured marking identifying the terminals in your plug, proceed as follows:

The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is

marked with the letter E or by the earth symbol

or coloured green or green-and-yellow.

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or

coloured blue.

The wire which is coloured brown must be connected to the terminal which is marked with the letter L or

coloured brown.

* In order to prevent possible electric shock, please install the grounding wire to the earth wire connecting

screw at the rear of the water oven in case of no 3 holes socket available in your residence.

OVEN DIAGRAM

1. Door open button

2. Oven lamp

3. Door hinges

4. Door safety latches

5. See through door

6. Door seals and sealing surfaces

7. Coupling

8. Waveguide cover (Do not remove)

9. Control panel (see page E-4)

10. Ventilation openings

11. Power supply cord

12. Turntable

13. Roller stay

14. Rating plate

R-220,R-222 [02 EN+TOC].indd Sec1:3R-220,R-222 [02 EN+TOC].indd Sec1:3 6/27/13 5:06:44 PM6/27/13 5:06:44 PM

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Kommentare zu diesen Handbüchern

Keine Kommentare

Sharp R-222 Spezifikationen Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mikrowellen Sharp R-222