Sharp R-652M Betriebsanleitung PDF herunterladen (Seite 23)

Great Plains Manufacturing, Inc. Table of Contents Index Preparation and Setup 19

2015-01-26 Table of Contents Index 401-652M

Monitor Setup

Refer to Figure 19

The standard DICKEY-john

PM300 system monitors

the following elements of a YP4-6-825A3P planter:

• Seeds at each row unit seed tube.

• Ground speed.

See “Seed Monitor Console Installation” on page 113.

Refer to the DICKEY-john

PM300/PM332/PM400

Operator’s Manual for monitor operations.

After installation, and prior to ﬁrst ﬁeld use, the monitor

must be setup with the row spacing and speed sensor

constant, as well as your preferences for information

display. Row count is auto-assigned, but any other

factory defaults are not likely to be correct for your

planter.

Row spacing data may be found in the Appendix.

For speed setup, Great Plains recommends using the

400-foot calibration described in the DICKEY-john

manual, rather than using a theoretical “# of pulses”.

Perform the calibration run in representative ﬁeld

conditions, as soil conditions, surface looseness and

other tillage practices can cause variations in the

effective rolling radius of the ground drive wheel.

Prior to each planting session, set any desired limits for

speed and population for the current crop.

Marker Setup (Option)

Prior to ﬁrst use, check and adjust:

•“Marker Speed Adjustment” on page 114.

Prior to ﬁrst use, and whenever changing row spacings,

set or reset:

•“Marker Extension” on page 115.

Prior to each planting session, check and adjust:

•“Marker Disk Adjustment” on page 42.

Figure 12

Monitor Primary Screen

29971

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 127 128

Keine Kommentare

Sharp R-652M Betriebsanleitung Seite 23