Sharp AN-LS1 Spezifikationen PDF herunterladen (Seite 9)

Connections

Connecting Devices

Connect a commercially available controller or computer and a projector to AN-LS1.

Connecting a Controller or a Computer

In the case of controlling a projector via RS-232C as well as via the Ethernet LAN, connect a

commercially available controller or computer to the RS-232C (CONTROLLER) terminal.

RS-232C (CONTROLLER)

Controller

(commercially available)

Computer

To RS-232C terminal

RS-232C serial control

cable

(commercially available)

• For connection procedures for each device, please refer to the operation manual for each device.

• Make sure not to connect a controller or a computer to the RS-232C (PROJECTOR) terminal.

• Set as follows for the Port settings for RS-232C.

Baud Rate : Set the same value as AN-LS1. (Page 11)

Data Length : 8 bits

Parity Bit : None

Stop Bit : 1 bit

Flow Control : None

• In the case of connecting to a controller, use a suitable cable for the RS-232C cable.

• In the case of connecting to a computer, use a cross-over type cable for the RS-232C cable.

Connecting a Projector

Connect a projector to the RS-232C (PROJECTOR) terminal.

RS-232C (PROJECTOR)

To RS-232C terminal

RS-232C serial control

cable

(commercially available)

Projector

• For connection procedures for a projector, please refer to the operation manual for the projector.

• In the case of connecting to a projector, use a cross-over type cable for the RS-232C cable.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 53 54

Keine Kommentare

Sharp AN-LS1 Spezifikationen Seite 9