Sharp R-55TSF Betriebsanleitung PDF herunterladen (Seite 29)

ASSEMBLY

Assembly Section 2-3

FRONT PUMP MOUNTING

Install the pump mounting bracket on the front of the tractor with capscrews and washers as

shown in the Parts Section illustration. DO NOT tighten fasteners at this time.

Slide the pump drive shaft into the crankshaft adapter. The end with the external threads

should be inserted into the adapter.

Slide the splined drive shaft coupler onto the pump drive shaft. Install the pump onto the

mounting bracket. NOTE: The shaft is offset to one direction, the pump should be installed with

the offset side on top. Install hardware for securing pump to the pump mount, DO NOT tighten.

Align pump so that splined coupling can be moved back and forth by hand. Tighten pump

mounting bolts in succession rechecking for spline coupling movement. Remove the pump

mounting bracket bolts one at a time and apply a tread locking agent. Tighten these bolts in

succession, again checking for free movement in the drive shaft. After all bolts are torqued, the

end play on the drive shaft should be 1/16” to 1/8”, and coupler should move freely with hand

pressure. If end play is less than 1/16”, grind the end of the shaft to achieve the proper end play.

If there is more than 1/4" of end play, return the shaft with specifications for a longer shaft.

CAUTION: DO NOT START THE TRACTOR UNTIL ALL HOSES ARE ATTACHED, TANK

IS FILLED WITH PROPER OIL AND BALL VALVES ARE OPEN! STARTING AT THIS TIME

WILL CAUSE SERIOUS DAMAGE TO THE PUMP.

(ASM-MF-0002)

ADJUSTING REAR WHEELS

Raise rear of tractor onto jack-stands. Follow the instructions in the tractor owners

manual for adjusting tires and rims.

The wheels need to be switched to the opposite sides of tractor. The left side needs to be

set to the widest possible setting. The right side needs to be set to one notch in from the widest

setting. Also take note of any width restrictions when transporting by trailer. For ease of

installation, it is best to leave the rear wheels removed during installation of the mower.

(ASM-MF-0003)

MAIN FRAME INSTALLATION

With an overhead hoist and / or jack-stands, raise one side of the frame up to the

correctly matching mounting holes. Install capscrews and all other hardware as shown in

main frame parts section to secure the sides of the main frame to the tractor casting, DO

NOT tighten at this time. Remove the capscrews one at a time and apply a thread locking

agent. Reinsert the capscrews and tighten / torque to values noted in the torque chart

located in the maintenance section of this manual.

(ASM-C-0003)

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 247 248

Keine Kommentare

Sharp R-55TSF Betriebsanleitung Seite 29