Sharp e-Copy ShareScan Bedienungsanleitung PDF herunterladen (Seite 35)

eCopy ShareScan OP Installation and Setup Guide | 31

Configuring Send to eCopy

The Send to eCopy tab is available on the eCopy ShareScan OP Administration Console only after

you license the ScanStation using a Send to eCopy product key (see "Licensing the scanning device"

on page 20).

To configure Send to eCopy:

Click Start > Programs > eCopy Applications > ShareScan OP Administration.

2 In the console tree, click Devices > device_name > Manage > Send to eCopy.

3 Under Configuration, specify the number of seconds. ScanStation looks in the storage folder

for files older than the specified time and then deletes them.

4 Under Location, specify the following information about the target storage folder:

Type — Select SMB or FTP.

Folder — For an SMB location, enter the path to the shared folder, such as: C:\Sharp_drop or

\\FileServer\Sharp_drop. For an FTP location, specify the FTP folder, such as: \scans or

\scans\HR.

Hostname — For an SMB location, enter the hostname or the IP address of the computer

where the ShareScan OP server is installed, such as:

10.10.9.111. For an FTP location, enter

the IP address of the FTP site, such as:

10.10.12.245.

the name must match the FTP user name, such as:

FTPeCopy.

Password — Enter the password associated with the user name.

5 Click Save.

6 Restart the ScanStation client.

Sending to the scan destination

To send to the scan destination:

Load your originals into the MFP.

2 Press the Image Send button on the control panel.

3 Press Address Book on the touch screen.

4 Select the scan destination.

5 Press the green Start button on the control panel to start scanning.

1 2 ... 30 31 32 33 34 35 36 37 38

Keine Kommentare

Sharp e-Copy ShareScan Bedienungsanleitung Seite 35