Sharp AH-X10BE Bedienungsanleitung PDF herunterladen (Seite 14)

Left Door Assembly

8.1: Rest Left Door (118) on the ground with front side down.

Position Deadbolt Latches (HM) in slots at the top and bottom

of door then slide Door End Channel (AG) onto the door.

Door End Channel ﬁ ts onto door

with the ﬂ at side up (facing the

Dead bolt Latches).

Hardware Bags:

1033168

Rubber Mallet

(Not Actual Size)

HM (2)

You may need to nudge the Door End

Channel to make the holes line up

with the gap in the door.

Back of

Door

Hardware Bags:

1033168, 1033418

Screwdriver

HC (2)

HL (2)

PB (3)

VC (3)

7/16” Wrenches (2)

8.2: Slip the Strike Plate (HU)

over the Left Door and align the

holes.

8.3: Attach the Left Door Latch

(HP) to the Strike Plate with two (2)

Carriage Bolts (HC) and two (2) Cap

Nuts (HL).

8.4: Attach the Left Door Handle

(BB) using three (3) Washers (VC)

and three (3) Screws (PB).

TOP

BOTTOM

Truss & Roof Installation

14.1: Place a Truss into the ﬁ rst set of notches behind the Front Gable.

Be sure to carefully read and follow the roof installation instructions and notes.

Following each step in the order listed will minimize potential complications

during installation.

14.2: Place a Roof Panel (114) between the Truss and the Front Gable. Be

sure the alignment nub in the Roof Panel ﬁ ts into notch on the Truss.

Top of Roof Panel

Truss Channel

Roof Panel

Nub

Be sure the nub in

the Roof Panel ﬁ ts

into the notch in the

Truss.

Truss

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Sharp AH-X10BE Bedienungsanleitung Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Split-System-Klimaanlagen Sharp AH-X10BE