Sharp 21F-A30 Betreibershandbuch PDF herunterladen (Seite 164)

MAINTENANCE AND SERVICING

Form 169000 / 169040 162 Revision C

c. Lift forming shield onto bolts (N) in windrower

legs, and secure with clevis pins (M) and hairpin.

d. Lift the aft end of the forming shield and attach

straps (O) to pins (P) on windrower frame.

Install washer and hairpin to secure strap. Use

the middle hole and adjust height to suit the

crop.

e. Set forming shield side deflectors to desired

width by re-positioning adjuster bars (Q). Use

same hole location on both sides.

f. Adjust fluffer shield (R) to middle position.

Loosen handles (S) if required.

7.13.6 Hydraulic Drive Motor Removal: All

Models

a. Open shield covering conditioner drive.

b. On pull-type machines, disconnect the hydraulic

hoses from the motor, and install caps on hose

ends and motor ports.

c. On self-propelled machines, disconnect hoses at

couplers on motor.

d. Remove the two bolts (A) securing motor to

gearbox, and remove motor.

7.13.7 Hydraulic Drive Motor Installation:

All Models

Install the hydraulic drive motor onto the

gearbox (A) as follows:

a. Clean off excess sealant from motor flange and

gearbox face.

b. Apply light coat of silicone to motor flange, and

position motor on gearbox as shown until

mounting holes are aligned, and pinion engages

gear in gearbox.

c. Install bolts (A) and washers and torque to

75 ft·lbf (102 N·m).

d. Re-connect hoses to motor.

BOTH SIDES

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 191 192

Keine Kommentare

Sharp 21F-A30 Betreibershandbuch Seite 164