Sharp 21F-A30 Betreibershandbuch PDF herunterladen (Seite 178)

MAINTENANCE AND SERVICING

Form 169000 / 169040 176 Revision C

7.16 GAUGE ROLLERS

The gauge rollers can be removed for

replacement or repair. Proceed as follows to

remove the gauge rollers:

Removal:

a. Raise header, and engage lift cylinder stops.

CAUTION

Stop engine, and remove key from ignition

before leaving Operator's seat for any

reason. A child or even a pet could engage

an idling machine.

b. Remove bolts and clips (A) from forward edge of

gauge roller assembly.

NOTE

Use a socket and ratchet wrench to

access the nuts.

c. Remove hairpins on pins (B).

d. Support gauge roller, and remove pins (B).

e. Disengage tabs on mounting plate from slots in

cutterbar to remove roller assembly.

Installation:

a. Position gauge roller assembly below cutterbar,

and insert tabs on roller assembly into slots (C)

in frame. Secure with two pins (B) at “lowest”

position.

b. Attach clips (A) with bolts and nuts to secure

roller assembly to cutterbar.

NOTE

Use a socket and ratchet wrench to

access the nuts.

c. Tighten nuts.

d. Remove pins (B), and adjust rollers to desired

height. Re-install the two pins (B).

e. Ensure that nut (D) on each pin registers in

adjacent hole in support bracket.

f. Secure pins with hairpins (E).

7.17 ELECTRICAL

a. Use electrical tape and wire clips as required to

prevent wires from dragging or rubbing.

b. Keep lights clean, and replace burned bulbs.

c. To replace light bulbs:

1. Using a Phillips screwdriver, remove screws

from fixture, and remove plastic lens.

2. Replace bulb, and re-install plastic lens and

screws.

Bulb Part No. - Trade #1156

SP HAZARD LIGHT

PT TAIL LIGHT

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 191 192

Kommentare zu diesen Handbüchern

Keine Kommentare

Sharp 21F-A30 Betreibershandbuch Seite 178

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Fernseher & Monitore Sharp 21F-A30