Sharp AL-1651CS Wartungshandbuch PDF herunterladen (Seite 41)

AL-1651CS DISASSEMBLY AND ASSEMBLY 8 - 2

2) Set the charger cleaner to the transfer unit, and move it recipro-

cally a few times in the direction of the arrow shown in the figure

below.

E. Charger wire replacement

1) Remove the TC cover and remove the screw.

2) Remove the spring and remove the charger wire.

3) Install a new charger wire by reversing the procedures (1) and (2).

At that time, be careful of the following items.

• The rest of the charger wire must be within 1.5mm. Refer to Fig.1

• The spring hook section (charger wire winding section) must be in

the range of the projection section.

• Be careful not to twist the charger wire.

2. Operation panel section

A. List

B. Disassembly procedure

1) Open the side door, and Open the front cover.

2) Remove the screws (4 pcs.), the harness, and the operation panel

unit.

1mm

1.5mm

Fig.1

Charger wire

Protrusion

No. Part name Ref.

1 Operation panel unit

2 Operation PWB

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 159 160

Keine Kommentare

Sharp AL-1651CS Wartungshandbuch Seite 41