Sharp CD-M4000 Betriebsanweisung PDF herunterladen (Seite 182)

Replacing the HV Pothead

4-92 72A-1230 Rev. F

July 22, 2005

Figure 4.52 HV Pothead, Ground Screw Location

4. Remove one screw and washer (Figure 4.52), that secure the ground wire

and the power outlet wire to the side of the HV Pothead, using a

Phillips-head screwdriver.

5. Carefully lift the HV Pothead out.

6. Unpack the replacement HV Pothead and place it onto the Front Panel

Assembly.

7. Replace four #632 nuts with flat washers, into the corners of the black

plate beneath the HV Pothead, using an 11/32” socket wrench.

8. Grasp the ground wire and the power outlet wire (Figure 4.52) and place

them back onto the side of the HV Pothead. Secure these wires by

replacing the screw and washer using a Phillips-head screwdriver.

9. Replace the 1/4” elastic nut, on the back of the Front Panel Assembly to

secure the W30 cable, using a socket wrench.

10. Replace the Front Panel Assembly by following steps 9-14, ”Removing

and Replacing the Front Panel Assembly” on page 4-58.

11. Replace the top and front covers by reversing the steps in ”Removing the

Front and Top Covers” on page 4-46.

Ground Screw

1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 203 204

Keine Kommentare

Sharp CD-M4000 Betriebsanweisung Seite 182