Sharp R-957M Bedienungsanleitung

Installation & Operators ManualInstallation & Operators Manual Part number 902.0005 Revision E Jan 2012 Language English The Classeq Pass Thr

1 3 1 5 5 5.4 Machine ready to operate : It is IMPORTANT after switching the appliance on each day, to allow 25 minutes before starting the f

5 5 4 1 5.6 Draining (cont.) : Drain pump appliances • Switch appliance OFF at fascia . • Open the hood, wait for the blue

6.0 Cleaning6.0 Cleaning 6.1 Prior to cleaning : Switch off and isolated electrical supply before cleaning the appliance WARNING

6.3 Exterior cleaning : Wipe the exterior of the appliance with a damp sponge (NOT WET) Once dry, clean using a STAINLESS STEEL cleaning agen

Page 12 7.2 Appliance fills slowly : • Check water supply tap is fully open. • Check water supply pressure, should be above 2 bar, if not ask yo

• Check water supply is ON and fully open. • Rinse dishes of any food debris before placing into the dish-washer. • Glasses may need to be renovate

8.0 De8.0 De--commissioningcommissioning If for any reason you require to remove or, de-commission your appliance, then do so in accordance

NotesNotes ………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………

Pass through Description & Part number Hydro 857 Hydro 957 Drain pump DP2 Optional Optional Wash pump 0.74kW 522.0002   Wash element

  CLASSEQ, Winterhalter House Roebuck Way Milton Keynes MK5 8WH Affix Stamp

Installation and Operation instructionsInstallation and Operation instructions For pass through range of commercial glass & dishwashers. Section

  Thank you for buying a quality ‘ClasseqClasseqClasseqClasseq’ product, please complete and post this form without delay Your new appliance is supp

CAREFULLY READ THESE INSTRUCTIONS, BEFORE INSTALLING AND OPERATING THIS APPLIANCE. PRIOR TO REMOVAL OF ANY EXTERIOR PANELS, ENSURE THE MACHINE I

2.0 Your Classeq appliance2.0 Your Classeq appliance 2.1 Unpacking : Use suitable means and protective equipment to avoid injury whils

Page 3 3.2 Connections : All mains connections are made at the rear of the appliance D = Mains electrical supply lead E = Earth bonding / Equ

3.4.2 Drainage systems All appliances require a Ø40mm (1 1/2”) standpipe, appliances are available with pumped or gravity drain, they must all be

Page 5 4.1.2 Chemical dosage : Chemical doses are pre-set, however they can be adjustment to suit the Individual sites requirements, such adjus

Page 6 4.2 Rinse & wash tank temperatures : The water temperatures on ’Classeq’ range of machines are adjustable, but have been preset, and

1 5 Page 7 5.0 Operation5.0 Operation 5.1 Machine description : The design of commercial glass and dishwashing machines differ from t