Sharp R-230L Betriebsanleitung PDF herunterladen (Seite 6)

2. General warnings

2.1 Don’t attempt to use the hydraulic saw system and DS-WSS 30 wire saw accessory modules without having

received the appropriate training from an authorised Hilti specialist.

2.2 Always use the hydraulic saw system in accordance with the wall saw operating instructions and supplementary

wire saw system operating instructions. The operating instructions must always be kept at hand. The instructions

on anchoring and securing the system must be observed.

2.3 Approval must be obtained from the site engineer or site management before sawing. Sawing work can negatively

affect the stability of a building or other structure, particularly when reinforcing bars or supporting members are

cut through. Ensure that there are no concealed gas, water, electricity or other supply lines in the area in which

sawing work is to be carried out.

2.4 The area in front of, behind or below the surface where sawing work or drilling is to be carried out must be secured

in such a way that persons or equipment cannot be injured or damaged by falling blocks of concrete or by con-

crete slurry. Where necessary, cores or blocks of concrete should be secured to prevent them from falling.

2.5 Operators and all other persons must stay clear of the area when a load is being lifted by a crane.

2.6 Concrete blocks with a weight of several tons may be sawn out with the Hilti saw. Measures for securing and

transporting these concrete blocks must be planned and implemented. Make use of the steel wedges contained

in the set of tools for securing concrete blocks. Keep the working area clean and tidy and cordon off openings.

2.7 National regulations and laws, as well as the operating instructions and the safety information applicable to

the accessories employed must be observed.

2.8 The D-LP 32 (30) / DS-TS 32 (30) / DS-WSS 30 saw system must NOT be operated in environments where a risk

of explosion exists unless special safety precautions are taken.

Printed: 08.07.2013 | Doc-Nr: PUB / 5069762 / 000 / 01

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Keine Kommentare

Sharp R-230L Betriebsanleitung Seite 6