Sharp R-370E Betreibershandbuch PDF herunterladen (Seite 20)

6.0 Installation & Setup

6.10 Three Phase Hook-Up

The power source is connected to the cutter through the bottom of the power panel (right hand side).

A main power control switch and power cord providing the machine with power is the responsibility of

the customer and should be set in accordance with the local electrical code.

1. DISCONNECT AND LOCK OUT THE POWER (See Power Lockout procedure, page 5)

2. Thread the power cord through a conduit connector into the power panel.

3. Fasten the ground lead to the ground terminal lug (Figure 11).

Figure 11

4. Fasten the three power leads to the three terminals of the main power terminal block- L1, L2,

& L3.

5. Close the electrical panel doors and latch them. Unlock the main panel and turn on the

power. Turn on the main power disconnect switch located on the front face of the table.

6. Press both cut buttons simultaneously to activate the motor and check to make sure it is

turning the same direction as the arrow on the motor casing.

If it isn’t, disconnect the power and exchange any two leads (L1, L2 or L3) of the power cord as in

Figure 12, page 20. The motor will now turn the correct direction.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 58 59

Keine Kommentare

Sharp R-370E Betreibershandbuch Seite 20