Sharp R-323T Spezifikationen PDF herunterladen (Seite 19)

NEVER OVERFUSE A CIRCUIT. REPLACE BLOWN

FUSE WITH EXACT REPLACEMENT INDICATED

BY NORCOLD. OVERFUSING OF A CIRCUIT CAN

RESULT IN A FIRE.

12. Reconnect the DC input leads to the terminal

block (See Figure 10). Insure that the correct

polarity is observed.

Manual Shut-off Valve Removal

& Replacement

USE TWO WRENCHES WHEN TIGHTENING OR

UNTIGHTENING GAS FITTINGS. LEAK TEST AF-

TER WORKING ON ALL GAS FITTING. FAILURE

TO DO SO COULD RESULT IN A FIRE OR EX-

PLOSION WHICH COULD CAUSE PERSONAL IN-

JURY OR DEATH.

1. Turn off the gas supply at the main tank.

2. Remove the inlet gas supply line from the shut-

off valve connector (flare fitting).

3. Remove the outlet tube fitting from the shut-off

valve connector (flare fitting).

Note: Do not remove the brass fittings attached

to the valve body.

4. Remove the two screws from the shut-off valve

bracket.

5. Remove the two screws that secure the shut-off

valve to the bracket.

6. To reinstall follow the reverse order 5 through 1.

7. Leak test all gas fittings removed.

Control Assembly Removal

& Replacement

1. Turn off the gas supply at the main tank.

2. Remove all wire connections from the Terminal

Block, tagging each wire or otherwise identifying

for reconnection later.

USE TWO WRENCHES WHEN TIGHTENING OR

UNTIGHTENING GAS FITTINGS. LEAK TEST AF-

TER WORKING ON ALL GAS FITTINGS. FAILURE

TO DO SO COULD RESULT IN A GAS LEAK

WHICH COULD RESULT IN A FIRE OR EXPLO-

SION, WHICH COULD CAUSE PERSONAL IN-

JURY OR DEATH.

3. Remove the inlet flare fitting to the Gas Control

Valve.

4. Remove the outlet flare fitting from the Gas Con-

trol Valve.

5. Remove the screw that secures the Control As-

sembly to the cabinet.

6. Lift the Control Assembly away from the cabinet.

7. Remove the clips that secure the capillary tube

to the fins, noting that the capillary tube is lo-

cated on the fifth fin from the right.

8. Pull the capillary tube through the back of the

cabinet.

9. To reinstall, reverse the above procedure.

10. Leak test all gas fittings removed.

Gas Control Removal & Replacement

USE TWO WRENCHES WHEN TIGHTENING OR

UNTIGHTENING GAS FITTINGS. LEAK TEST AF-

TER WORKING ON ALL GAS FITTINGS. FAILURE

TO DO SO COULD RESULT IN A GAS LEAK

WHICH COULD RESULT IN A FIRE OR EXPLO-

SION WHICH COULD CAUSE PERSONAL INJURY

OR DEATH.

1. Turn off the gas supply at the main tank and at

the manual shut-off valve.

2. Remove the inlet tube flare fitting from the Gas

Control Valve.

WARNING

1 2 ... 14 15 16 17 18 19 20 21 22 23

Kommentare zu diesen Handbüchern

Keine Kommentare

Sharp R-323T Spezifikationen Seite 19

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mikrowellen Sharp R-323T