Sharp R-610D Handbuch PDF herunterladen (Seite 41)

Installation

3-17

Part 1105120-01

E 2013 Nordson Corporation

The exhaust blower and duct size for each application will depend on many

variables. Size all blowers to accommodate all losses in the ductwork and

ensure that the specified air flow and pressure for each lamphead is

maintained.

AirShield Ventilation System

Figure 3-12 shows a standard AirShield Ventilation System kit installed on

an external blower lamphead. A high flow AirShield kit is also available.

Before mounting the lamphead on the AirShield enclosure, switch the

pressure hose from the top or front port to the bottom port as described in

Switching Pressure Ports on page 3-18.

Use eight M4 screws to mount the AirShield enclosure to the lamphead.

The internal blower lampheads are mounted to the kits in the same way.

Refer to the Parts section for the AirShield kit part numbers.

NOTE: Recommended Flexible Duct Hose for exhaust extraction:

McMaster-Carr part number 55125K26, neoprene coated 6-in ID hose. Use

worm clamps to connect the hose to the vent stubs.

8−M4 x 35 Screws (Std Kit)

8−M4 x 50 Screws (High Flow Kit)

(included in kits)

6-in. Exhaust

6-in. Intake

Quartz Plate

High Flow Kit

Standard Kit

48.1 mm

(1.894 in.)

38.1 mm

(1.5 in.)

25.4 mm

(1.0 in.)

35.4 mm

(1.394 in.)

Top Pressure Port

Port for Bottom Pressure Reading

Figure 3-12 AirShield Kit Installation (External Blower Lamphead Shown)

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 143 144

Keine Kommentare

Sharp R-610D Handbuch Seite 41