Sharp 32L-X2000 Bedienerhandbuch Seite 2

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 77
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 1
Repair and maintenance of the Tirak hoist should
always be accomplished in a safe environment!
The purpose of this sheet is for quick reference
only. Most troubleshooting solutions can be
found on pgs. 17 & 18 of the Tirak Instruction
Manual included with each hoist.
2
WARNING
This sheet is to be used by certified Tirak
technicians only!
Table 001
BASIC TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE
High amps and/or heat
Low power
Centrifugal switch (stuck closed)
Start capacitor defective
Stator burned
Brake drag
Water damage
Hoist overloaded
Hoist frozen electrically (ie. Won't run in either direction
Brake rectifier defective
Run capacitor defective
Brake coil defective
Fuse defective
Hoist goes up but not down Blocstop has been activated
Up and/or Down button does nothing
E-stop button has been activated
Fuse defective
Hoist goes down when up button is pressed
Centrifugal switch (stuck open) defective
Capacitor (start and/or run) defective
Hoist will not lift a suspended load
Start capacitor defective
Low power
Slightly higher amps than normal Run capacitor defective
Fuse in control circuit blows immediately
Main relay coil short circuit
Fuse defective
Thermal protector is burned
Seitenansicht 1
1 2 3 4 5 6 7 ... 76 77

Kommentare zu diesen Handbüchern

Keine Kommentare