Sharp R-880S Betreibershandbuch PDF herunterladen (Seite 46)

Unit Operation

Turning the Unit On and Off

IMPORTANT: Verify the Base Controller On/Off Switch is

turned on before turning on the HMI Control Panel. The

Base Controller On/Off switch is located on the outside of the

control box side of the unit.

If the Standard Truck HMI Control Panel is turned

on and the Base Controller On/Off Switch is turned

off, the HMI display screen will flash on and off.

The unit is turned on by pressing the ON Key and

off by pressing the OFF Key. When the ON Key is

pressed the display briefly shows dashes as the

display initializes.

IMPORTANT: If the display flashes on and off

continuously when the ON Key is pressed, check to

make sure the Base Controller On/Off switch is in

the ON position.

Figure 19: Keys and LED Indicators

Then the unit running time hourmeters are shown for 30

seconds. The diesel engine run time hours and Diesel Icon are

shown in the upper display. If the optional Electric Standby

Feature is installed, the electric motor run time hours and

Electric Icon are shown in the lower display.

A Full Pretrip Test is initiated from this display by pressing and

holding the Pretrip Key as shown later in this section.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 110 111

Keine Kommentare

Sharp R-880S Betreibershandbuch Seite 46