Sharp R-880S Betreibershandbuch PDF herunterladen (Seite 68)

Unit Operation

Sending a ServiceWatch Data

Logger Start of Trip

When the unit is turned on, press and hold the ENTER Key for

5 seconds to send a Start of Trip (SOT) marker to the unit

ServiceWatch Data Logger and the optional DAS Data Logger

(if equipped).

Figure 40: ENTER Key

Pretrip Test

A Pretrip Test verifies unit operation. The PRETRIP Key

allows either a Full Pretrip Test or an Engine Running Pretrip

Test to be initiated by the operator.

Pretrip Test Conditions

• The current unit settings are saved and restored at the end

of the Pretrip Test or if the unit is turned off and back on.

• The Pretrip Test can be run in either Diesel or Electric

Mode.

• The unit will auto switch from Diesel Mode to Electric

Mode or from Electric Mode to Diesel Mode during a

Pretrip Test if these features are enabled and the auto

switch conditions occur.

Conditions where Pretrip Tests are

not allowed

• Pretrip Tests are not allowed if any shutdown alarms are

present.

• Pretrip tests are allowed with some Check and Log alarms

present.

Pretrip Test Sequence

Pretrip tests proceed in the order shown below.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 110 111

Keine Kommentare

Sharp R-880S Betreibershandbuch Seite 68