Sharp R-880D Bedienerhandbuch PDF herunterladen (Seite 42)

STP-200/300/400 Series Instruction Manual

3) When installing the damper in the inlet port flange

Refer to Table 3.2 for rotational torque.

In case of using a damper, secure the base with all 8 screw-holes for legs

or all 8 attached legs. Follow "CAUTION" on page 3-9 about legs and

bolts for securing the base.

When the base cannot be secured because of the equipment design, install

the pump with a torque restraint like the one shown in Figure 3.7 (b).

◇ Use a damper only at the vertically upright position.

◇ DO NOT remove the bolts and nuts attached to reinforce the damper.

Leg

Hole to prevent

from rotating

Damper Clamps

Secure the base

Vacuum Equipment Vacuum Equipment

(a) When securing the base (b) When installing not to rotate

Figure 3.7 Example of securing the STP pump

(When installing the damper in the inlet port flange)

3-12

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 129 130

Keine Kommentare

Sharp R-880D Bedienerhandbuch Seite 42