Sharp R-880D Bedienerhandbuch PDF herunterladen (Seite 54)

STP-200/300/400 Series Instruction Manual

4.3 Attaching the STP Control Unit to a Rack

The dimensions of the STP control unit front panel conform to EIA standard.

Therefore, this panel can be attached to any type of commercially-available racks.

Attach the STP control unit to the rack according to the following steps:

1) When attaching the STP control unit to a rack:

• Attach the front panel to a rack using the screw holes for the front panel.

• Also support the STP control unit from the bottom using a support angle

or a similar tool.

2) When attaching the STP control unit to a movable rack:

• Attach the front panel to a movable rack using the screw holes for the

front panel.

• To protect the STP control unit during transport, remove the rubber foot

from the bottom and attach the STP control unit to the rack using the

screw holes for the rubber foot.

◇ The STP control unit cannot be supported with only the screws on

the front panel (The STP control unit is a heavy product).

Always support it from the bottom. DO NOT block the ventilation port.

◇ For the peripheral space of the STP control unit, see Figure 4.4,

"Peripheral Space of the STP Control Unit."

◇ For the dimensions of the front panel and positions of screw holes

for the rubber foot, see Figure 16.3, "External Appearance of the STP

Control Unit."

part: Secure with screw

Support Angle

Figure 4.5 Example of Securing the STP Control Unit

4-9

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 129 130

Keine Kommentare

Sharp R-880D Bedienerhandbuch Seite 54