Sharp R-880D Bedienerhandbuch PDF herunterladen (Seite 46)

STP-200/300/400 Series Instruction Manual

4 Installation of the STP Control Unit

4.1 Name and Function of Each Part

4.1.1 Front Panel

(See Figure 4.1.)

(1) "POWER ON/OFF" Switch (illuminated alternate push button switch,

green LED)

・ Press this switch to power ON/OFF the STP pump (valid in

MANUAL operation only).

・ The POWER ON/OFF built-in lamp lights when the power is ON.

(2) "MOTOR START" Switch (momentary push button switch, black)

・ Press this switch with power ON to start and accelerate the STP

pump (valid in MANUAL operation only).

・ The "ACCELERATION" lamp lights simultaneously.

(3) "MOTOR STOP" Switch (momentary push button switch, red)

・ Press this switch to decelerate and stop the STP pump (valid in

MANUAL operation only).

・ The "NORMAL OPERATION" lamp or the "ACCELERATION"

lamp goes out.

(4) "NORMAL OPERATION" Lamp (green LED)

・ Lights during rated operation (NORMAL OPERATION state).

(5) "ACCELERATION" Lamp (green LED)

・ Lights during acceleration (ACCELERATION state).

(6) "OVER TEMPERATURE" Lamp (red LED)

・ Lights when any of the following abnormalities occurs:

a) When the motor or electromagnet overheats (90 °C or more).

b) When the STP connection cable is not connected.

(7) "BATTERY OPERATION" Lamp (red LED)

・ Lights while the power is being supplied from the battery to the

STP pump during a power failure.

4-1

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 129 130

Keine Kommentare

Sharp R-880D Bedienerhandbuch Seite 46