Sharp SD-AT1000W Spezifikationen PDF herunterladen (Seite 147)

Maxiva UAX

October 17, 2013

3‐79

888‐2693‐004 WARNING:Disconnectprimarypower priortoservicing.

Note

The indicators on this screen display the status of the input commands described in Table 3-70 on page 3-

78. These inputs enter the transmitter via the 25 pin male Transmitter Interface connector on the LPU rear

panel. The connector pin numbers are provided.

Note

The UAX Transmitter will default to standalone mode when no connections are made to the parallel I/O.

If the TCU present signal is asserted at anytime, the transmitter will be forced into dual mode for opera-

tions with a TCU. The transmitter will remain in dual mode until power cycled with the TCU present sig-

nal de-asserted. When in dual mode, the parallel I/O will be operational regardless of remote control

setti

ng enabled/disabled. When in standalone mode, the parallel I/O will be disabled when remote control

is disabled

RemoteEnable

IndicatedtheremotecontrolstatusoftheLPU.Greenisenabled,Blueisdisabled‐inputonpin5.

Note:InStandaloneoperation,theRemoteControlcommandisignored.

AutoPowerCtrl

Auto/ManualPowercontrolcommand.GreenisAuto,BlueisManual‐inputonpin18.Note:In

Standaloneoperation,theAutoPo

werCtrlcommandisignored.

Excit erOFF T r ansmitterOffCommand.Greenisactive,Blueisinactive‐inputonpin4

TCUPresent TCUPre s en tIndication.Greenisactive,Blueisinactive‐inputonpin19.

ExciterON TransmitterOnCommand.Greenisactive,Blueisinactive‐inputonpin3

RestrikeCmd

ManualFaultResetCommand.Whe

nintheOnstate,thiscommandwillresettheautomaticfault

restrikeprocessing.Greenisactive,

Blueisinactive‐inputonpin17

Table3‐70Status>TransmitterI/O

Field Explanation

Status

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 291 292

Keine Kommentare

Sharp SD-AT1000W Spezifikationen Seite 147