Sharp AR-810 Wartungshandbuch PDF herunterladen (Seite 80)

AR-651/810 CONTROL PANEL 5 - 5

5. 2. 2. Display in abnormal condition

No. Message

1 Add paper

2 Add toner

Press [HELP]

3 Set key copy

counter

4 Paper misfeed in

bypass

5 Misfeed in copier

Press [HELP]

6 Misfeed in copier

Press [HELP]

7 Misfeed in doc.

feeder

Press [HELP]

8 Misfeed in finisher

Press [HELP]

9 Misfeed in

INSERTER

10 Call for service

11 Time for periodic

maintenance

12 Check paper in LCF

13 —

14 Select the same

sized Tab sheets as

the originals

Abnormal state and indication on display panel

Paper run out [Fig.5.2-1 A]

- The cassette with no paper flashes.

Toner run out [Fig.5.2-2 B]

- The toner cartridge is empty.

- The message is displayed and the copier is

stopped.

Key copy counter not installed [Fig.5.2-1 C]

- The key copy counter was pulled out when

copier was ready for scanning.

- The copier is stopped when the key copy

counter is pulled out after the [START] key

was pressed.

Bypass paper jam [Fig.5.2-2 D]

- Paper jam at the bypass tray

Paper jam in the copier [Fig.5.2-2 E]

Misfeeding of cassette paper [Fig.5.2-2 F]

- Paper fed from the cassette does not reach

the feed sensor in a fixed time.

Original jam [Fig.5.2-2 G]

- Original jamming in RADF

Paper jam in the finisher [Fig.5.2-2 H]

Paper jam in the inserter [Fig.5.2-2 I]

Motors, sensors, switches, etc. do not work

properly. [Fig.5.2-2 J]

PM cycle

- Time for maintenance

- Copying is possible.

Paper misloading in the tandem LCF

- Displayed when a paper is set out of alignment

Toner bottle full

- The toner bottle is full of used toner.

The copier stops its operation. [Fig.5.2-2 K]

Displayed when the paper sizes for the tab

sheets and originals are different

Solution

- Add paper to the cassette.

- Select a different cassette.

- Replace the toner cartridge and close

the front door.

- Insert the key copy counter (option).

- Remove the paper from the bypass

tray.

- Press the [HELP] key and remove the

paper following the messages

shown on the display panel.

- Press the [HELP] key and remove the

paper following the messages

shown on the display panel.

- Open the jam-access cover and

RADF unit to remove the original.

- Press the [HELP] key and remove the

paper following the messages

shown on the display panel.

- Press the [HELP] key and remove the

paper following the messages

shown on the display panel.

- Turn OFF the power and solve the

problem, then turn ON the power again.

- Maintenance and inspection are per-

formed by a qualified service techni-

cian.

- Set the paper correctly.

- Replace the toner bag with a new

one and close the front cover.

- Select the same size for tab sheets

and originals.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 341 342

Kommentare zu diesen Handbüchern

Keine Kommentare