Sharp R-440/540 Betreibershandbuch PDF herunterladen (Seite 153)

918496/GP0313 145

Final Shutdown / Decommissioning

Important: Dispose of all materials properly. Used oils/fluids/gases/refrigerant

are environmental contaminants and may only be disposed of at approved

collection facilities. Never drain any oils/fluids onto the ground, dispose of in

municipal waste collection containers, or in metropolitan sewer systems or

landfills. Check state and local regulations for other material disposal

requirements.

If the machine will no longer be used as intended, shutdown, decommission and

dispose of it according to the valid regulations.

Before Disposal

1. Shutdown the machine according to valid regulations regarding proper shut-

down.

2. Park the machine on level, dry ground. Ensure the surface can support the

weight of the machine. Ensure the location is protected against access by

unauthorized persons.

3. Lower the lift arm completely. Remove any attachments.

4. Place forward/reverse drive switch (on top of the joystick) into the neutral

position and apply the parking brake.

5. Move the throttle to the low-idle position and allow the engine to cool for

approximately 2 minutes.

6. Shut off the engine.

7. Wait for all movement to stop. Turn the ignition key to the “I” or RUN posi-

tion and move the multi-purpose joystick in all directions to verify that the

hydraulic system is de-pressurized. Verify that the joystick does not cause

movement of the lift arm.

8. If so equipped, press the auxiliary hydraulics pressure relief control. After

pressing, make sure this control returns to the neutral position.

9. Turn off the ignition. Switch off all electrical switches.

10. Unfasten the seat belt, remove the ignition key and take it with you.

11. Ensure the machine cannot be operated after shutdown until further disposal.

12. Ensure no environmentally hazardous materials, fluids and/or fuel can escape

the machine. Specifically check for leaks form the engine, the hydraulic sys-

tem and the coolant system.

13. Ensure the machine poses no dangers in the place where it is standing.

14. Remove any dirt and/or debris from the engine compartment, the chassis and

the cylinder rod surfaces.

15. Remove the battery.

16. If so equipped, lock the cab door. Lock the engine compartment. Remove the

key(s) and take it/them with you.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 179 180

Keine Kommentare

Sharp R-440/540 Betreibershandbuch Seite 153